Gansu Nantong Daly shears hotline: 0931-2318727 13609323355 18189528244 Xining Sales Tel: 18309716428 Contact: Taojing Li, Gansu hydraulic shears borrowed in motion on the blade and fixed lower blade, using reasonable blade clearance, for sheet metal of various thicknesses applied shear force, the sheet material separated by the desired size of the fracture. Lanzhou hydraulic shears divided according to the shape of scissors and shears straight knife cutting disc shears. Straight knife cutting into the goal by tectonic shears shears and throat. Circular knife cutting into the disc constructed in accordance with shears, rolling shears, multi-disc shears and rotary trimming shears, hydraulic shears allowed Gansu cut laminate material, are not allowed Trim the edges of the sheet edges are not allowed to cut the pressure is not tight and short narrow sheet material. The gap between Lanzhou hydraulic shears blades should be based on the thickness of the sheet to alignment, but not larger than most of the 1/30 panel. Blades should be securely fastened, the upper and lower blades faces remain parallel, using artificial disk drive test after alignment, to avoid accidents. Gansu hydraulic shears blades should be kept sharp edge, such as edge becomes dull or crack phenomenon, should be replaced, when cut, pressing device should be firmly pressed sheet metal, are not allowed in the press is not tight cut in the state. Lanzhou hydraulic shears have equipment hydraulic equipment, in addition to cutting the outer throttle valves not permitted to other hydraulic alignment, Gansu hydraulic shears operate in strict accordance with the rules, before each boot according to the lubrication chart requires timing, location, Dosing lubricants, oil should be clean and free of precipitation. The machine must be kept clean, unpainted part of anti-rust oil. Yang motor bearing lubrication oil inside the filling should be changed regularly, and always check the electrical part of work safety. Regularly check the V-belt, handles, knobs, buttons damage, severe wear should be replaced, and report to the spare parts to add. Check carefully before cutting ministries work is normal, the electrical equipment is intact, the lubrication system is smooth; clear around the table and placed tools, measuring tools and other debris and scrap materials. Shears according to a predetermined thickness, adjust gap scissors shears. Not allowed to simultaneously cut two kinds of different specifications, different material sheet; do not stack shearing. Cut the sheet surface roughness requirements, can not be allowed to cut the compacted narrower sheets.